1, clean

Bearing will be removed when check, use first method such as photography and then record the appearance. In addition, to confirm the amount of residual lubricant and lubricant sampling, and then clean the bearing.

A, bearing cleaning divided into rough washing and fine washing, can be put in use at the bottom of the container and on the metal frame.

B, rough washing, oil using a brush to remove grease or adhesive. If at this time in oil bearing, pay attention to the loss due to foreign bodies such as rolling surface.

C, fine cleaning, slowly rotating bearings in the oil, must be carefully.

Commonly used cleaning agent for neutral aqueous diesel or kerosene, according to the need to sometimes use warm lye, etc. No matter use which kinds of detergent, often should filter clean.

After cleaning, coating anticorrosive oil or antirust grease on the bearing immediately.

2, checking and judging

To determine remove the Static Load Rating Of SKF 6206 Bearing can be reused, to inspect the dimension precision, rotating accuracy, internal clearance and mating surface, raceway surface, cage and seal rings etc.

About the test results that can be used by bearing the judgement or master of bearing.

Judgment standard according to the mechanical properties and important degree and inspection cycle. If you have the following injury, bearing shall not be used again, must be replaced.

1) bearing fracture and defect of the parts.

2) stripping of the raceway surface things rolling.